Skip to main content
Surfaces
CommandRaise Lower CommandDifficultyintermediateAdded2027.0Statusdraft

Raise/Lower Points Command

Raises or lowers multiple COGO points with the specific amount, or sets an elevation for multiple COGO points.

When to use this function​

Use this function when you need to:

  • [Scenario].

Before you begin​

  1. [Prerequisite or preparation step].

Start the command​

Enter Raise Lower Command at the Civil 3D command line.

Location on Compact Ribbon:

Location on Extended Ribbon:

Procedure​

  1. Run the command.

  2. Select the COGO points.

  3. Specify the value to add or deduct (negative value) from the COGO points elevation, or set the elevation:

    idas-raise-lower-points-command screenshot

Expected result​

[Describe the observable successful outcome.]

Troubleshooting​

[Symptom]​

[Actionable resolution.]

  • [Link to a directly relevant topic]