Skip to main content
StormwaterWastewater
CommandSwap Ends CommandDifficultyintermediateAdded2027.0Statusdraft

Swap Structures to Inlets Command

Checks for structures with only one pipe connection. A storm water network branch rarely starts with a manhole, if the structure style is set to manhole, it will swap it to an inlet style. This command swaps all structures to the same inlet type, as defined by the user.

When to use this function​

Use this function when you need to:

  • [Scenario].

Before you begin​

  1. [Prerequisite or preparation step].

Start the command​

Enter Swap Ends Command at the Civil 3D command line.

Location on Compact Ribbon:

Location on Extended Ribbon:

Procedure​

    1. Run the command.
    2. Specify the properties. The Change To Inlet window shows a list of manholes with only one pipe connection. It excludes outfalls which would also only have one pipe connection.

Result:

Expected result​

[Describe the observable successful outcome.]

Troubleshooting​

[Symptom]​

[Actionable resolution.]

  • [Link to a directly relevant topic]