Skip to main content
Water
CommandWeed Pressure Profile CommandDifficultyintermediateAdded2027.0Statusdraft

Weed Pressure Network Profile Command

Weeds a pressure network profile. All the vertices that are not at the pressure structures (fittings and appurtenances) are removed so the profile editing becomes much easier.

When to use this function​

Use this function when you need to:

  • [Scenario].

Before you begin​

  1. [Prerequisite or preparation step].

Start the command​

Enter Weed Pressure Profile Command at the Civil 3D command line.

Location on Compact Ribbon:

Location on Extended Ribbon:

Procedure​

In the image below, the pressure structures are represented by a blue triangle. The structures that will be removed are marked with the red arrow:

  1. Run the command.

  2. Select a pressure pipe run profile in the profile view.

Result:

Expected result​

[Describe the observable successful outcome.]

Notes​

  1. The vertices that are ± 0.1 m from the pressure structure are not removed because there were some drawings where the vertices were not aligned exactly with the pressure structure.

  2. This command only works in Civil 3D 2022 and newer.

Troubleshooting​

[Symptom]​

[Actionable resolution.]

  • [Link to a directly relevant topic]